Locating bolt holes in replacement saw handles

I finished shaping a replacement handle for an old Disston saw today (there is more to come on this saw), only to face the challenge of drilling the holes for the saw bolts. Rather, as the drilling itself is a trivial matter, I should say the challenge of accurately matching the holes to those already in the blade.

Given the moderate rarity of this saw, enlarging the existing holes in the blade was not an option, so I needed to align the holes in the new handle with them very closely. Since the vast majority of my work is on new saws, this was a new problem, and one which had me staring into space for a few minutes.

After some thought, I came up with a solution which undoubtedly has been used by others, but which I have not yet seen described. Its chief advantage lies in being able to mark the holes while the handle is positioned on the blade. All that is required is a flat surface, a piece of tape, a square.  And a pencil, which, despite a fascinating collection of mechanical pencils and leadholders, is invariably the single most difficult item to find in my shop. (I have seen your shop, and would argue that finding an unoccupied flat surface is the real challenge. -Ed.)

Mark the heel of the blade on the tape, then align the square with the horizontal center of the hole. Mark this location on the tape, then read the vertical location of the center of the hole and write that on the tape.

Mark the heel of the blade on the tape, then align the square with the horizontal center of the hole. Mark this location on the tape, then read the vertical location of the center of the hole and write that on the tape.

Showing the marks and measurements for the centers of the holes.

Showing the marks and measurements for the centers of the holes.

With the handle on the blade, transfer the measurements to the handle. Make sure that the heel of the blade is positioned on its mark, or all of the holes will be off.

With the handle on the blade, transfer the measurements to the handle. Make sure that the heel of the blade is positioned on its mark, or all of the holes will be off.

It doesn't get much better than this.

It doesn’t get much better (or easier) than this.

This entry was posted in Saw repair. Bookmark the permalink.

3 Responses to Locating bolt holes in replacement saw handles

  1. Jonathan says:

    That’s a great tip Isaac. Thanks for sharing it.

  2. Alex says:

    …and timely, too! I just picked up a sweet little dovetail saw in need of a better handle, and this was the only problem I had not solved. Thanks for sharing!

Leave a Reply to Jonathan Cancel reply

Your email address will not be published. Required fields are marked *